Patlite ILB-12LJAW Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
9
6
5-2 Activating the siren sound by connecting to the siren amplifier (SAP-100WB)
6
7
8
9
1
10
5
4
3
White(Speaker High)
Brown(Speaker Low)
Green(Speaker Common)
Horn
Horn Relay
Battery
Cut Wire
Gray(Horn Relay)
Orange(Horn Switch)
Yellow(Radio)
Blue(Radio Ground)
Red(Plus Power Source)
Black(Ground)
Battery
Radio
System
Microphone
SAP-100WB
Horn Switch
Green
White
Unused
(To be insulatede)
For siren control by means of the
vehicle horn switch
For amplifying the sound of
the walkie-talkie
Red
F
F:fuse
SW
SW:switch
Ry
Ry:switch auxiliary relay
Black
To amplifier
Battery
White
Green
3 1
4 2
5
6
5-1 For flashing function only
OFF
Stop
Flashed
ON
LED total assembly operation
Switch:SW
※Switch operation
※Fuse specification(F)
Operating voltage
Fuse rating
7.5A
12V
*)Orange
*)Grey
*) For HWS-LJAW Only
Joint plate
Driver unit
Nominal 5x12 round-head tapping screw(※)
3) Procedure for exchanging the driver unit
Follow the procedure below to replace the driver unit:
① Turn OFF the power (turn the switch OFF) of the multi visual revolving warning light.
② Remove the main and middle dome assemblies (see Replacing the domes on page 9).
③Loosen the four screws (nominal 5x12 round-head tapping screws) holding the joint plate in place
and slide the plate (either to the left or to the right).
Holding the connector of the leads (green and white) connected to the driver unit and remove
the connector.
Hold the driver unit and turn it counterclockwise to remove it.
Install a new driver unit by turning it clockwise.
 ※To connect the terminals, push the driver until all the way to the end once and pull it back to
the position that allows the connection of the terminals and tighten them again securely.
After the connection to the driver unit is completed, attach the joint plate and
   the dome assemblies.
White lead
Green lead
11Ω
※Wire the driver unit as shown below:
White or Green lead White or Green lead
White or Green lead
Vue de la page 6
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire