Patlite HP Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
4. To connect the wire
5. To change the bulb
2. Cautions
3. Installation
2 3
Sealing ring
Sealing
Wire entry areas
(Wire )
Wire
C.L
C.L
Front or rear
Front or rear
(Bottom view)
Body
Sealing ring
Mounting surface
HEX. HD. Bolt (M6×20)
Drain way
WIRE
Bulb
Pull out
Install
Connector
Unlock
Spring
Lock
Socket
HEX. Nut (M6)
Lock washer
Flat washer
Body bottom
Check the voltage before use.
Do not operate without the dome.
Switch off the light when changing the bulb.
Do not touch the bulb just after turning it off, as it may cause a burn.
Close the dome firmly to appropriate lock position.
Do not rotate the reflector with fingers.
Do not wash our product with high pressure water.
When cleaning the dome, wipe carefully with the water moistened linen.
Do not use thinners, benzine, gasoline or oil.
Do not supply oil to the motor and rotor.
Do not touch the glass of bulb when changing the halogen bulb.
When the glass of bulb becomes soiled, dampen a cloth with alcohol to wipe
clean.
No guarantee shall be given to any defect caused by the use and remodeling
beyond the scope of the instruction manual.
1). Mount the sealing ring on the body
bottom.
Mounting direction of the sealing ring
is according to the drawing.
Cautions
1). Do not change the bulb before
turning off the switch.
2). Do not touch the bulb just after
turning it off, as it may cause a burn.
How to remove the bulb
1). Unlock the spring for the bulb.
2). Pull out the bulb from the connector.
How to install the bulb
1). insert the bulb firmly into the
connector.
2). Put the bulb in the socket, along the
flat side.
3). Secure the bulb with the spring.
Secure and wire according to the
drawing, wires are led in through the
wire entry areas, paying attention to the
polarity of them.
2). Lead the wire into revolving lamp
through the wire entry areas
(WIRE) on the rear side of the
body.
Cautions
WIRE
For safety operation and to ensure best bulb performance, please wear
working gloves.
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire